Making a slide from a favourite bottle
A bottle with a story can become a slide with a story, as long as you check the fit, the glass and the edges before it goes near your guitar.

Plenty of players want a slide that came from a particular bottle: a wine from a wedding, a drink from a trip, a shape they simply like. It is a nice idea, but not every bottle makes a good slide. Here is what to think about before you start.
Start with your finger
The slide has to fit the finger you will wear it on, usually the ring finger or the little finger. Measure that finger at the knuckle and at the base, because a slide must pass over the knuckle and then sit snugly.
- Wrap a thin strip of paper around the finger at its widest point, mark the overlap, and measure the strip with a ruler.
- Divide that length by about 3.14 to get the diameter.
- Check the inside diameter of the bottle section you plan to use. It should be slightly larger than your knuckle, with a little room to spare.
Fingers swell in warm weather, so measure at the time of day you normally play.
Look at the wall thickness
Thickness changes how a slide feels and sounds. Thin glass is light and bright but can be fragile. Thick glass is heavier, sustains longer and gives a rounder tone. Many bottles are thinner near the shoulder and thicker near the base, so look at several points along the length.
Very thin or uneven walls, or glass with visible scratches or bubbles, are best left as ornaments. A slide takes pressure from your finger and knocks against strings and frets.
Cut edges need careful smoothing
A freshly cut bottle has sharp edges that can cut skin and chip further in use. Smoothing is the most important step, and it is worth doing slowly.
- Wear eye protection and keep the work area tidy and well lit.
- Rub the edge with wet-and-dry abrasive paper, starting coarse and moving to fine grits, keeping the paper wet.
- Round both the inside and outside of the rim, not just the top.
- Run a fingertip gently around the edge. If anything catches, keep sanding.
- Wash away all glass dust before handling.
If you are not comfortable cutting glass, ask a glass workshop or a maker who cuts slides to do it for you. You can see how finished slides are made on the slide shop page, or read the slide questions page.
Test before you trust it
Put the slide on and shake your hand. It should not fall off, nor feel tight enough to pinch. Then play a few notes on a low-stakes guitar and listen for rattles or scratches. For help with the playing itself, the tuning guide is a good next step.