How to choose the right slide size
A slide that fits well feels like part of your hand, and getting there takes a tape measure, a little patience and a few minutes of testing.

Why fit matters
A slide that is too loose spins and slips when you bend a note. One that is too tight is hard to put on, hard to take off, and can leave your finger sore after a long session. The aim is a snug, secure fit that still lets the slide move on and off without a fight.
Step 1: Measure your finger
You need a strip of paper or thin string, a pen and a ruler.
- Wrap the paper or string once around the finger you plan to use, at the spot where the slide will sit. This is usually the middle of the finger or just below the top knuckle.
- Mark where the end overlaps the start.
- Lay it flat and measure the length between the marks in millimetres. This is the circumference.
- Divide that number by 3.14 to get the diameter of your finger.
For example, a circumference of 60 mm gives a diameter of about 19 mm.
Step 2: Choose an inner diameter
Inner diameter is the width of the hole through the slide. Your finger measurement is the starting point. Most players add a little room so the slide can pass over the knuckle, since the knuckle is wider than the spot where the slide rests.
- Measure the knuckle as well as the resting spot, using the same paper method.
- Choose a size that clears the knuckle without much force.
- If you fall between two sizes, think about how you play. Players who move the slide on and off often tend to prefer the looser one. Those who keep it on all night may prefer the closer fit.
Fingers change through the day. They are often slightly larger in warm weather or in the evening, so measure when your hands are at a normal temperature.
Step 3: Think about length
The slide should cover the full width of the finger section it sits on, so the strings meet glass, metal or ceramic rather than skin. A longer slide covers more strings and feels steadier, but it adds weight and can be awkward for single-note lines. A shorter one is lighter and more precise, though it can be harder to keep flat across several strings.
If you play mostly chords, lean longer. If you play single-string melodies, a shorter slide is often more comfortable.
Step 4: Pick your finger
There is no wrong answer here, but each finger has its own feel.
- Little finger: leaves three fingers free for fretting, which suits players who mix slide with regular chords.
- Ring finger: a popular balance of control and freedom, and a common choice for open tunings.
- Middle finger: strong and steady, though it leaves fewer fingers for fretting.
Try each one for a few minutes. Your choice may also depend on your tuning, so the tuning guide is worth a look.
Next steps
With a diameter and length in mind, browse the slide range or read the common questions. If you would like help, get in touch.